How to Decorate Your Decoiler Machine?

Decoiler Machine is one of the most famous manufacturers of stamping machines. The manufacturer offers high quality products for small-scale and large-scale industries. It is known worldwide for its top-notch equipment and repair services. All products have similar material property and characteristics. When products vary, production line with similar machines can be easily switch.

Decoiler Machine

However, in reality, decoiling equipment has very little restriction to simply stamping flat surfaces. Only certain parameters you have to think about is the maximum size of coil that can be run. There is another limit, but it is not so big that you cannot run the machine on standard machines. There is another limit which you cannot cross as well, which is the uncoiling limit.

You can use your regular sized coil sheets with decoder machine. As there is only limited space inside, if you try to use bigger coil sheets, then the operation will be difficult and time consuming. If you do not want to cross any of the limits, then it will be better if you stick to using standard size coils on your declining production line.

Maximum inner diameter of the flat plate is 9.5 inches and the outer diameter must be at least 18 inches. For standard applications, this will ensure adequate performance of the device. The other factor you should consider is the type of material you will be working with, which is flat plate or galvanized steel sheet.

Decoiling is a process where the two metal plates are slid side-by-side in order to form a coil. The key to maximize the performance of the machine will depend on the loading capacity. For standard loading capacity, the galvanized steel sheet can provide the best results. However, if the number of coils is less than eight, then it is better to go with a flat plate. Since the loading capacity is an important factor in determining the efficiency of the decoder machine, it is important to check the loading capacity periodically.

Another important aspect that you should consider when using this equipment is the leveler straightener. This is used to set the level of the coil stock width. If the leveler straightener is not of good quality, then there is a possibility of damaging the plates. There is also a chance of shorting of the wire when using this device. If you want to maximize your production line’s productivity, then you should consider using good quality leveler straightener.